1. Hanging lug type
This installation method is the lifting lug and honeycomb plate separated, the lifting lug is connected to the glue seam position of the honeycomb plate after separate processing, the suitable width of the glue seam is ≥12mm, this installation method makes the processing simple and easy to install.
2. Flanging type
This installation method is to process aluminum honeycomb panels when processing with installation flange, installation only need to comfort the connection and keel and glue seam can be, suitable for glue seam width of ≥ 10mm, this method is easy to install, but the processing is slightly more complicated, not suitable for modeling curtain wall panels.
3. Grab type
This node is aluminum profile type, the profile is a specific profile, the installation is simple, but this method has high requirements for plate processing accuracy, and it is not recommended to use it for plates with a length greater than 3000mm. Depending on the width of the profile, 20mm and 40mm, etc. are sewn into the plate.
